2012 Continental Gt rear camara NOT working , code (Front Parking Aid Warning Buzzer -H22 ) any Help to locate this h22 Please . I just buy the Buzzer H22 but need location . Thank you

 

Hello @ReyNODARSE ,
Being that you have a 2012 GT, I believe that you do have the two separate front and rear buzzers, apposed to the 2004-10/11 GT's that used 4 of the speakers in the audio system for the beep/tone.

So, if the 2012 GT is like the 2006 and up Flying Spur, and my 2005 Audi A8L W12, the front H22 buzzer is located behind the Instrument cluster.

Johnny

 

Thank you , Johnny let me try , I let you know

 

did you manage to find the location of the front buzzer?

thank you

 

Hello thanks for your help . we open the cluster and not found the h22 buzzer other diagram show in the center of dash if you can help me locate this h22 buzzer I will appreciate,
Thank You Rey

 

@ReyNODARSE ,
You say you "open the cluster", the h22 is not inside the cluster, it would be mounted to the dash behind the cluster, or in that general vicinity.

This is where the A8L has it mounted.

Johnny

.

 

Hello
I take out the cluster and not find the buzzers some diagram shoing in the center of the dash

 

When I put reverse I hear a buzzer noise in the driver sides quarter panel but i need to know where is locate the one in the front , but is not behind of the cluster i remove my cluster and is not there some of the diagram show in the center of the dash

 

My Bentley is from 2012 to 2018 according with Bentley 2010-2011 is different

 

​​​​​​Hello @ReyNODARSE ,
Yes, 2004 to 2010/11 is different as I previously said, as the earlier systems used four speakers of the audio system to alert.
After some searching, I found that the 2012 + has the front speaker/buzzer located behind the Infotainment head unit, see screenshots below.

Johnny
.

 

@ReyNODARSE ,
What was the outcome here, did you find the buzzer behind the Infotainment head unit ?

Johnny

 

see the picture
2014 Bentley GTC

speed

 

i’m getting the same error, but I checked the buzzer and tested it. It’s working fine. Could it be the PDC unit? Does anyone else know?

 

One of the bumper sensors can fail and throw the code. To test the sensors put the vehicle in drive with the engine not running. Stand in front of the sensor and try to feel or hear a faint buzzing from the sensor itself. A silent sensor is bad. This procedure has worked on non Bentleys. So give it a go...nothing to lose.

 

Hello @ReyNODARSE ,
What happened here ?

Johnny