Service manual... where do I find one: looking for a 2011 PTT. TIA

 

believe it or not, some found on ebay searching for oem service manual. I looked briefly found few for under 20 bucks.

 

my 2016 pan4 fuel door hinge holding the door is broken tonight. I don't know how? I realize when I open it while filling the gas at Chevron gas station. I can close it. I already make an appointment to bring my car to Porsche dealer to get fix. My car is still under warranty. This task is not an easy, I don't see any screw to remove it. I see note from Ciaka how to DIY.
Another run to dealer ...

 

Same here. I bought a fuel filler pocket on ebay for $75 with a white cover. Dropped it off my Porsche certified body shop to paint the cover. I'm going to carefully remove the old one and replace with the used one I bought that looks like a new one. Porsche wants about $250 for the pocket and cover flap new from Suncoast. Little nervouse about doing it but I'm patient and mechanically skilled. So I'll post after I finish.

 

Done !!! my wife 2016 PAN4 is under warranty. The fuel filler door is replaced under warranty - part number is 970-504-194-10 Fuel Filler Cup . Happy !!!
I got a 2018 PAN4s Volcano Grey color and red interior, a fully loaded car with all options, $132K sticker price. The 2018 PAN4S drives FANTASTIC, quiet and very Smooth d ... I feel lag and hear no sound of porsche exhaust sound when I accelerate full throttle from 65 to 90. thermal insulated glass option. LOL ... Just for a minute on I880 freeway. We Love the new car .... 2018 CPO PAN4 Hybrid is faster ... and only $84K now. $125K new ... LOL ...

 

Literally just fixed the hinge on my filler. The pin in the hinge rode up and I was able to put back into place.

these forums are the absolute best!

 

Does anyone know where I can buy the gas cap holder (when filling, put it into the hole for it to rest in)... cant seem to locate

 

Hello murci930, I'm pretty sure all I need to do is strighten or realign this fuel door hinge pin, how do I get to it?

Thanks! Turbotod

 

I just did this. You don't have to destroy your fuel door pocket. Take the outer door off first by putting a small flathead screwdriver into the slot and sliding the cover off. You just need to move the locking pin back an inch or so by loosening the two phillips head screws and moving it towards the rear of the car slightly. This will free up the back of the pocket. If you push a small sharp flathead screwdriver through the two small oval slots at the rear of the pocket, you will be able to put in two paint can openers. push in on the paint can openers, which will disengage the locking tabs, and pull out and the rear of the pocket should pop free. You can then slide the whole thing out towards the rear without touching the two forward ovals. You have to take it out towards the rear because the hinge goes far forward into the body and won't just pull out without sliding it to the rear. I had the same problem with the hinge pin walking up causing the door to wobble. I put the pin back in place and melted the end of the pin slightly flat with a soldering iron so that it wouldn't walk out again, hopefully.

 

I made a DIY for this while back.
Read through before you start. Take care.
Click here