HotRodGuy, now that you have used the wagner IC's 3.5 on your car are they performing for you ? would you buy them again ? thx Ed

 

[QUOTE=eds996tt;4765304]HotRodGuy, now that you have used the wagner IC's 3.5 on your car

I've had the 3.5 wagners for about 5yrs/90k. Repeated pulls still keeps temps consistently low. From what I remember at least 15 degrees? compared to the stock IC's
I'm sure there's better ones out there but can't beat the price on these

 

I'm happy with them, but i also don't have something to compare them to or any logging done to see temp drops.

 

So HotRod Guy.... then no logging ..understood... then was there a noticeable difference after the swap.... Curious where do you see the difference...?

 

The 5.7 are such a clean setup. If I ever go big HP I think I will get them.

 

+100

 

wagner 5.7 is a real good setup...my GT2 run perfekt with it

 

Since this thread is getting resurrected, can someone post a picture like this of the Wagner cores to give an idea of the fin density? I've asked this before. This is a picture of the Marston Aerospace cores for comparison..