I've got it running on the stand. First start I had oil blow all over and found out that I forgot to tighten my oil pressure sender. Got it tight and everything is good. I should be driving this week. I will have to test it under load before I can claim victory, but things are looking good. Video from instagram:

 

Great work my friend! Hoping all goes great!

 

What kind of power do you guess that will put down after rebuilding?

 

Not a whole lot at first. I have a 1.2 bar tune at the moment that I will run for a while. I will crank it up later on down the road. Just looking forward to doing some canyon carving and mountain climbing runs for now.

 

Awesome work, looking forward to hearing how test drive goes. Good luck!

 

Getting closer. Should be driving this weekend. I think I need to roll my rear fenders, 315's are tight.

 

Good luck!! It's been fun following your progress.

What are the specs on your wheels? I'm able to run 315/30/18 on an 18x12 ET43 without any rubbing.

 

They're 19x12 wheels with 315/25/19's. It's pretty close.

 

You'll probably have to roll fenders I had to roll mine with 305/30-19 PSS on 19x11s. I'm lowered on H&R springs.

 

I ordered a fender rolling tool and I ruined my power steering return line and had to order a new one because it leaks. Looking like next week now.

 

I have 19x12 HREs with 315's and no issues. Wonder what your offsets are?

 

I bet you are fine. But if not....

 

They are 19 X 9 F +54 OS and 19 X 12 R +45 OS according to the guy I got them from. They might fit and I'm just being paranoid. I will just roll the fenders a bit and be done with it. Either way, I'm glad I landed these wheels, I think they look fantastic.

 

Back on the road yet?

 

I'm still waiting on my power steering return line. I should have ordered from a more reliable source, but they did charge my card so maybe it will be here soon.